| View previous topic :: View next topic |
| Author |
Message |
dacari
Joined: 06 Feb 2009
Posts: 2
|
 Posted: Fri Feb 06, 2009 6:50 pm Post subject: IR Pass Though Causing Driver Failure |
 |
|
I am using the UBS-UIRT the relay IR signals to hidden equipment, but driver fails if the signal to be transmitted is the same that is recived. I have to reset by unplugging and re-installing drivers. This was happening in Event Ghost, so I thought it was a software issue because there was no wait to TX setting. I installed girder and set the wait to TX after RX any IR command to 100ms....but it still causes dirver failure. The unit will work without a hitch until I try to TX the same IR signal that is being RX. Any help on this issue would be appreciated. Thanks
WinXPsp3
Girder 5
USB-UIRT drv. 1.5 fir 5.9 |
|
| Back to top |
|
 |
dacari
Joined: 06 Feb 2009
Posts: 2
|
| Posted: Sat Feb 07, 2009 9:56 pm Post subject: |
|
|
| update...looks like it is not a pass through problem, but a specific ir command. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
