Unable to get Girder to learn more commands

[Sembiance]

I'm using Girder 3.3 and the latest USB UIRT drivers.
I just installed it a few minutes ago.

I loaded up Girder.

I chose to Add a new command.
I clicked Keyboard and chose the Special Key 'Enter'
I then Hit Apply, and then the 'Learn Event' button at the top.
It waited.. I hit a button on my remote.
Then Girder changed and showed me the command.
Everything works perfectly.

I did this 4 more times, for the Up, Left, Right and Down buttons.
Same procedure, no problems.

Then I followed the same steps, this time for the Esc button, (also tried the letter p)

NOW when I hit the 'Learn Event' a dialog pops up and says 'Girder Event' "Type commandline eventstring or select one of the Girder events"

This dialog has never come up before.
The drop down has a whole bunch of options, 'GirderOpen' 'OnSuspend' etc
If I choose the vent 'On Event' then the dropdown below it enables and allows me to choose between 'All' and 'USB-UIRT driver'
If I choose the UIRT driver, and hit 'Select' nothing happens.

I've tried hitting buttons on my remote at numerous times during this and no matter what I do I can't get Girder to add any more commands.

HELP!

[jrhees]

Hmmm, I have no clue... Have you asked this on the Girder forums?

-Jon

[sammck]

The dropdown to the left of "learn event" has to be set to "All" instead of "Girder Event" to learn from the remote.