USB-UIRT Forum

Hi,

Sorry for my very bad English but- I'm French!!

I've just receive my UIRT and it cannot learn codes from my Electrohome ECP remote.
The led is liting but no codes are learned by Girder.

Help me please.

Stéphane (west of France).

HCPASS,

Does the progress bar on the Learn dialog get to 100%?

If so, can you cut and paste the codes that appear in the 'Code1' and 'Code2' boxes?

Also: what model ECP do you have?

Thanks,

-Jon

Hi Jon,

Thanks for your very quick answer but noothink appear in the progresse bar and there is no codes in Code1 and Code2 boxes!!

I've an ECP 3000, i tried with ECP 4100 CCF but it could not works!

Stéphane.

I think you may have a ECP High-frequency remote which uses 336KHz carrier -- which would not work with USB-UIRT.

I know there is a 'universal' ECP .ccf on remotecentral.com which has both low-frequency and high-frequency prontocodes. You could try to import one of the low-frequency codes into Girder.

-Jon

Thanks jon

I'll tried to find this .CCF and test it!!


Stéphane.

Hi Jon,

I've found and test this "Universal" ECP .ccf, it's OK for parts of commands "StdBy" for example but the most important one "Power" is not Ok .

Another idea to help me?

Stéphane.

I would suggest trying .CCF's for some of the other ECP models. Often codes for one model will work with another. Also remember to make sure the 'Import as Raw' checkbox is CHECKED when importing and trying these codes.

Also, if you have to hold the power button on your remote for a long time you'll need to increase the 'Repeat' setting in Girder to simulate a longer button-hold.

-Jon

Ok Jon but for .CCF i use "NRIRServ". to control my AV amplifier, my CD Player and perhaps my ECP???

I only use Girder to control my PC's applications like "ZP" ,"DScaler", "Powerstrip" Etc....

I will try your suggestions.

Stéphane.