USB-UIRT Forum

I've tried pasting the pronto codes as described but still no luck. I need to send "E13 On" as part of my home theater play movie event. I'm able to paste the codes and can see that the USB-IRT is sending a code, but can't get it to work.

here are the codes I'm using:


13
0000 006b 0018 0000 00a5 0096 002e 00fe 002e 00fe 002e 00fe 002e 00fe 002e 00fe 008e 0096 008e 0096 008e 0096 008e 0096 008e 0096 01c2 0096 00a5 0096 002e 00fe 002e 00fe 002e 00fe 002e 00fe 002e 00fe 008e 0096 008e 0096 008e 0096 008e 0096 008e 0096 01c2 0e10


On
0000 006b 000c 0000 00a5 0096 002e 00fe 002e 00fe 008e 0096 002e 00fe 008e 0096 008e 0096 008e 0096 002e 00fe 008e 0096 002e 00fe 01c2 0e10

Obviously, If I use the Pronto itself, it works fine.

Are you using Girder? If so, I assume you're using the 'Import' button to paste in these Pronto codes...

If so, here's some things to try:

1. The 'Repeat' setting may either need to be set to '1' or high (try 10 or more) to control X10. The repeat setting simulates how long the button is held on your remote. You can try 'tapping' your Pronto to see if a short repeat works with your X10 gear.

2. If you are sending both of these codes in succession (13 followed by ON), you will need to make sure to put a Girder delay between the two codes, simulating the pressing and releasing of remote control buttons.

-Jon