USB-UIRT Forum

Having no luck with learning codes correctly.

I have found the codes from a working pronto remote .ccf file and will post the raw data here, but when i go to learn and then import (note: learning straight from the barco remote does not work) It gives an error saying that the first hex must be 0, but in my pronto remote the first hex is not 0 and it does work with the pronto remote.

Here are some codes if it helps you any

STDBY (power on/off)

0100 000c 002a 0000 0008 005f 0008 001b 0008 003c 0008 001b 0008 001b 0008 003d 0008 001b 0008 003c 0008 003d 0008 003c 0008 001b 0008 001b 0008 005f 0008 a79d 0008 005f 0008 001b 0008 003c 0008 001b 0008 001c 0008 003c 0008 001b 0008 003d 0008 003c 0008 003c 0008 001c 0008 001b 0008 005f 0008 a7a4 0008 005d 0008 001b 0008 003d 0008 001b 0008 001b 0008 003c 0008 001b 0008 003c 0008 003d 0008 003c 0008 001b 0008 001b 0008 005d 0008 005f

UP (arrow key)

0100 0008 0000 000e 0008 0092 0008 002a 0008 005e 0008 002a 0008 002c 0008 005e 0008 002a 0008 002c 0008 005e 0008 002c 0008 002c 0008 002c 0008 0090 0008 fcfc

DOWN (arrow key)

0100 0008 0000 000e 0008 0092 0008 002c 0008 005c 0008 002a 0008 002c 0008 005c 0008 005e 0008 002a 0008 005e 0008 002a 0008 002a 0008 002c 0008 008e 000a fcca

If you need more i can provide.

The Barco uses a special pulse-coded IR stream (no carrier). I am not sure if the USB-UIRT is going to be able to produce tose IR codes.

Has anyone had success with the Barco commands?

-Jon