USB-UIRT Forum

I'm using a Harmony 880 remote with my USB-UIRT, and there is an option for setting the time for inter-key delay in ms. Just wondering if you had a value (in 100ms increments), that is ideal for the USB-UIRT. I think I've got somewhere around 300ms in there right now, but things don't seem to move very fast when pressing the buttons on the remote quickly.

The remote codes that I'm using send alternating codes, both of which, have been learned on each command inside of SageTV. (i.e., for "Play" this requires two codes, each key press, it alternates between two different codes.) This probably isn't important, but I thought I would point it out.

For received IR, there is no 'ideal' delay, since just about anything greater than 30mS is usually taken as a valid code separator.

However, this may be more due to the SW you are controlling. Apps such As Sage may very well have debounce logic/timing inplemented which may prevent more rapid key sequences from working.

-Jon

Thank you. I will check with the Sage people, and see what their responce is.