by rhubarb » Wed Feb 02, 2005 4:05 pm
I'm still not clear on the Code 1, Code 2. I want to program girder to fire out a double digit channel change when it receives an event string.
E.g. I want to map the event string "channel 10" to the action, "remote button 1, remote button 0".
I want the 1 and 0 to be close together. The obvious choice was to use Code 1, and Code 2. But is that what this is for?
There seems no way to learn Code 2.
Is code 2 only for remotes that beam 2 codes at the press of a single button?
Or can I learn the code for button 0, copy/paste it into Code 2, then learn the code for 1 to get both?
If so, what about 3 digits?
OR is the proper way to do this do attach the second command to "do when finished".
How do I control the gap between the two button presses (this is the whole reason I need girder: the Media Portal USBUIRT plugin doesnt let me do this and its button presses are too far apart for my STB)
Also speaking to the original post in this thread, I have to say that the girder plugin is complex enough some documentation wouldn't go astray.
Even a nice big sticky post in this forum would be a start.
thanks
rhubarb