Parity problem with Force 320T DVB-T Box!?

[paanvst]

I have searched the usbuirt forum, but I have not found a thread with my problem. I hope someone can help me.

My problem is similar to those who can’t get double numbers to work (I think). I have installed the usbuirt and done the learning of my remote from the meedio configuration. This works fine, but when I push the Test button nothing happens unless I first push the corresponding button on the remote. For example, if I push the 3 on my remote, my DVB box switches to channel 3, and if I then push Test no. 3 in meedio config the box receives a no. 3 again. But if I push the 4 on my remote, and then Test no. 3 in config, nothing happens. I guess it is a parity problem. Does anyone know of a workaround for this? Could I put two signals per channel in the usbuirt config xml file for meedio?

/Patrik

[jrhees]

Patrik,

This *might* be a Parity problem -- it is hard to tell. I would suggect contacting support@usbuirt.com and asking for the lrnHelper app which can be used to investigate this further.

-Jon